該教程是演示6代自動調適配
The tutorial is demonstrating auto-adaptation of 6-generation HDDs

12代的自動調適配就不在這演示了。不過要注意的是12代的盤，如果固件是CC34的話，一定要刷到CC49的固件，因為CC34的固件對“W”指令支持不好，會導致盤不就緒或者其他問題。
12-generation HDDs automatic adaptation is not in this demonstration. However, note that for 12-generation HDDs, if the firmware is CC34, then we must brush to the CC49 firmware because the CC34 firmware does not support well for the “W” command. It will lead to disks’ not being ready or other problems.

段位測試只針對12代的盤有效。11代及以下都沒有用，只會測試一條ZONE的吞吐量。
The zone test is only valid for 12-generation HDDs. For 11-generation and below HDDs, this function can not be used. It will only test a ZONE throughput capacity.

1、點擊自動調適配會先做一系列初始化操作。
1. Click on the automatic adapatation, and a series of initialization operations will be done.

2、接下來就是默默等待了。
2. Wait for a while.

3、等自動調適配完成后，可以先看一下調整的情況，如果調整后的情況還有一兩條不正常，可以手動的修改相對應的適配參數，然后點“寫入ROM”，再將ROM用Bootcode模式寫入到硬盤中。直到滿意為止。
3. After automatic adaptation is completed, you can look at the adjustment of the situation. If one or two items are still not normal after the adjustment of the situation , you can manually modify the corresponding adaptation parameters, and then click “write to ROM” and write ROM to the HDD in Bootcode mode until satisfied.

注：自動調適配不是萬能的，不能把物理壞道給調好。這個盤的Head:0 Zone:0有物理壞道就不管了。
Note: automatic adaptation is not almighty. It can not fix the bad physical tracks.If there are bad physical tracks in Head 0 and Zone 0 of this HDD, you can leave them alone.

操作演示視頻

轉載請注明：成都千喜數據恢復中心 » 使用MRT為希捷硬盤自動調整適配